Find Out Information On How To Repair Rot And Decay On Wooden Windows

| Wednesday, July 27, 2011
By Nathan Madeley


Living in humid climate can cause your wooden fixtures to decay faster. You can find out how to repair rot and decay on wooden windows if you do not want to hire a pro to do it. Sure, you can hire a carpenter to fix your window but it will become costly if your windows decay often due to wet weather. You can fix minor damage yourself and save some cash.

A leaking gutter, rain, snow and humidity can lead to wood rot on your window sill. Do not delay fixing wood rot to prevent bigger damage and infestation from small pests like insects and termites. You can avoid bigger problems by fixing decaying wooden windows right away.

To get started with this DIY repair job, you can get some supplies at a hardware store. Some things you will need are: a chisel, drill, hammer, quarter of an inch drill bit, a paint brush, liquid epoxy consolidant, epoxy filler, some water, putty knife, and rough sandpaper.

Chip off the rotten wood with your chisel; tap it lightly to loosen up decaying wood. When you get all the rot out, you should be able to see good wood. Drill some holes on the exposed healthy wood with your drill. Place the holes about one to two inches apart.

Remove the dust and wood particles with the brush and then lay on a coat of epoxy wood consolidant on the drilled area. Fill the holes and surrounding area with the liquid epoxy and allow it to dry up for a few minutes. Put on a second coat of epoxy consolidant until the wood refuses to absorb anymore.

Allow the consolidant to dry completely into a solid mass. This tough surface will allow you to work on the wooden window without breaking the frame. Now, mix the epoxy filler with water as directed on the label. Check first if the epoxy filler you bought is ready to use before adding water. Apply the filler where the decayed part used to be.

Shape the filler to follow the other window frames to make it fit in properly. You can form it into shape with your knife too. Once you are done molding it into shape, use your sandpaper to refine the shape and flatten sharp areas. You can repaint your repaired window sill the same color as the other part of your window and you are done. Others will not even be able to tell that that window used to be rotten.




About the Author:



0 comments:

Post a Comment